Your cart

Your cart is empty

This Saker 4 in 1 Router Milling Groove Bracket Advantages:
  • RUGGED MATERIAL

    Upgraded thickened aluminum alloy material.

  • DETACHABLE DESIGN

    The base can be disassembled and used as the base of the trimming machine.

  • CLEAR SCALE

    The laser ruler and scale are clearly reflected.

GUIDE RULE FUNCTION

MILLING CIRCLE

1. Secure the trimming machine to the base by using screws.

2. Determine the desired radius length, slide the nail hole in the middle of the radius slider to the scale, and tighten the knobs on both sides.

3. Use 3mm nails to fix the center of circle and mill the circle.

4. Then you can mill out a full circle or half arc.

GROOVING

1. Loosen the radius slider knob, slide it to the far left or far right and tighten the knob on both sides.

2. Place the black positioning block in the middle of the guiding rule.

3. Stuck the ruler body in the groove of the guiding rule, and tighten the knob through the ruler body and the black positioning block at the bottom to secure.

4. Stick the guiding rule closely to the side of the board, and then slide the bracket and the trimming machine in parallel to make smooth grooving.

TRIMMER BASE FUNCTION

Loosen the knob near the base to get a detachable router base.

SUITABLE FOR A VARIETY OF BOARD MATERIALS

Saker 4 in 1 Router Milling Groove Bracket is So Easy to Use